产品详情
简单介绍:
华仪6730线性可编程交流电源
6700 线性可程式交流电源
6700 Series Linear Programmable AC Power Source
采新型的线性 (Linear) 放大线路设计,满足低噪声、高稳定性的要求(如网通、影音设备、监视系统...等应用)。 输出电压设定范围0 - 300V,频率设定范围45-500Hz,另可选购 0 - 600V 电压及 45-1000Hz
华仪6730线性可编程交流电源
详情介绍:
华仪6730线性可编程交流电源
|
6705 | 6710 | 6720 | 6730 | 6740 | ||
---|---|---|---|---|---|---|---|
INPUT | |||||||
Phase | 1 Phase | ||||||
Voltage | 115/230Vac ± 15% | 230Vac ± 15% | |||||
Frequency | 47-63Hz | ||||||
OUTPUT | |||||||
Power rating | 500VA | 1000VA | 2000VA | 3000VA | 4000VA | ||
Max. Current(r.m.s) | 0-150V | 4.2A | 8.4A | 16.8A | 25.2A | 33.6A | |
0-300V | 2.1A | 4.2A | 8.4A | 12.6A | 16.8A | ||
Max. Current(peak) | 0-150V | 16.8A | 33.6A | 67.2A | 100.8A | 134.4A | |
0-300V | 8.4A | 16.8A | 33.6A | 50.4A | 67.2A | ||
Option 0-600V | |||||||
Max. Current(r.m.s) | 0-300V | 2.1A | 4.2A | 8.4A | 12.6A | 16.8A | |
0-600V | 1.05A | 2.1A | 4.2A | 6.3A | 8.4A | ||
Max. Current(peak) | 0-300V | 8.4A | 16.8A | 33.6A | 50.4A | 67.2A | |
0-600V | 4.2A | 8.4A | 16.8A | 25.2A | 33.6A | ||
Phase | 1Phase / 2W | ||||||
THD(Total Harmonic Distortation) | <=0.5% at 45-500Hz (Resistive Load) | ||||||
Crest Factor | >= 4 | ||||||
Line Regulation |
0.1% max for a ± 10% line change. |
||||||
Load Regulation | <=0.5% (Resistive Load) | ||||||
Response Time | < 100µS | ||||||
SETTING | |||||||
Voltage | Range |
0-300V, 150/300V Auto or 0-600V,300/600V Auto(Option 0-600V) |
|||||
Resolution | 0.1V | ||||||
Accuracy | ±(0.5%+2 counts) | ||||||
Frequency | Range | 45-500Hz | |||||
Resolution | 0.1Hz at 45-99.9Hz , 1Hz at 100-500Hz | ||||||
Accuracy | ±0.02% of setting | ||||||
Frequency (Option 45Hz-1KHz) |
Range | 45-1000Hz | |||||
Resolution | 0.1Hz at 45-99.9Hz , 1Hz at 100-1000Hz | ||||||
Accuracy | ±0.02% of setting | ||||||
Starting& Ending Phase Angle |
Range | 0-360° | |||||
Resolution | 1° | ||||||
Accuracy | ±1°(45 - 65HZ) | ||||||
MEASUREMENT | |||||||
Frequency | Range |
45.0Hz - 500.0Hz 501.0Hz - 1000.0Hz (Opt.625) |
|||||
Resolution | 0.1Hz | ||||||
Accuracy |
±0.1Hz at 45.0 - 500.0Hz ±0.5Hz at 501.0 - 1000.0Hz |
||||||
Voltage | Range | 0.0-300.0V / 0.0-600.0V | |||||
Resolution | 0.1V | ||||||
Accuracy |
± (0.5% of reading +2 counts) for 0-300V ± (0.5% of reading +4 counts) for 0-600V |
||||||
Current(r.m.s) | Range | L | 0.000-3.500A | ||||
H | 3.00-35.00A | ||||||
Resolution | L | 0.001A | |||||
H | 0.01A | ||||||
Accuracy | L |
± (0.5% of reading +5 counts) for 0-300V ± (0.5% of reading +10 counts) for 0-600V |
|||||
H | ± (0.5% of reading +3 counts) | ||||||
Current(peak) | Range | 0.0 -200.0A | |||||
Resolution | 0.1A | ||||||
Accuracy | ± (1% of reading +2 counts) | ||||||
Power | Range | L | 0.0-350.0W | ||||
H | 300-4000W | ||||||
Resolution | L | 0.1W | |||||
H | 1W | ||||||
Accuracy | L | ± (0.6% of reading +5 counts) | |||||
H | ± (0.6% of reading +2 counts) | ||||||
Power Factor | Range | 0 - 1.000 | |||||
Resolution | W / VA ,Calculated and displayed to three significant digits | ||||||
Accuracy | |||||||
GENERAL | |||||||
Low Range Meter (for 6705/ 6710 Option) |
Range : 2.0mA - 350.0mA / 0.20 - 35.00W Resolution : 0.1mA / 0.01W Accuracy : ± (0.6% of reading +5 counts). |
||||||
Remote Input Signal(Option) | Test, Reset, Recall program memory 1 through 7 | ||||||
Remote Output Signal | Pass, Fail , Test-in Process | ||||||
Memory | 50 memories, 9 steps/memory | ||||||
Sync Output Signal | Output Signal 10V ,BNC type | ||||||
Timer | 0=Continuous, 0.1-999.9 (Unit: sec, minute, hour selectable) | ||||||
Alarm Volume Setting | Range: 0-9 ;0=OFF, 1 is softest volume, 9 is loudest volume. | ||||||
Graphic Display | 240 x 64 dot resolution Monographic LCD /Contrast 9 Levels 1-9 | ||||||
Auto loop cycle | By step or memory, or system loop cycle setting. 0=Continuous, OFF, 2~9999 | ||||||
Over Current Fold Back | On/Off , Setting On when output current over setting A-Hi value it will fold back output voltage to keep constant output current is setting A-Hi value. | ||||||
Protection | OCP, OTP ,OVP and Alarm | ||||||
Interface | GPIB / RS232 / Remote I/P Control option | ||||||
Dimension(WxHxD) mm | 430 x 89 x 400, 2U | 430 x 89 x 560, 2U | 430 x 267 x 650, 6U | 430 x 667 x 650, 15U | 430 x 667 x 650, 15U | ||
Net Weight | 25Kg | 36Kg | 90Kg | 165Kg | 192Kg | ||
Operation Environment | 0-40°C/20-80%RH |
华仪6730线性可编程交流电源
特点
- 采用先进的高密度电源技术设计,体积小,1KVA 容量高度只有8.9cm,节省测试空间
- 具有输出波形的启始及结束相位角设定,以及仿真电压瞬升及瞬降功能,可仿真多种电源状态
- 大型LCD 显示器 (240 x 64),可同时显示输出电压、频率、电流、功率、功率因子、及时间,测试信息一目了然
- 具有自动循环次数及以秒、分、时为单位的时间设定功能,可应用于不同被测物的寿命试验
- 浪涌电流可达额定电流的 3 倍,不需购买较大容量电源,即可轻易启动高启动电流负载(马达、压缩机…等),节省设备成本
- 测试输出期间,可实时调整电压或频率,不需停机再做调整,节省测试时间
- 可搭配0.1mA / 0.01W 高解析量测,节省外加Power Meter 的成本
- 瞬时反应快,在瞬间加重载或除载时波形可于100uS内恢复,节省测试时间
- 前面板万用插座,即插即用,节省配线时间

华仪6730线性可编程交流电源
索取详细资料请咨询:
华仪6730线性可编程交流电源华仪6730线性可编程交流电源